Відео

Seat altea kompresor 1ko 820803L klima słabo chłodzi,nieraz wcale,ciśnienie jest i gaz,to może być ten zawór?

Jakie były objawy?

What if you replace the entire PCV valve, not just the diaphragm and there is still suction there?

I have 2012 vw passat se 2.5l and the AC works only when the car is moving and even then it is not cold enough. A lot of people are saying the problem is the valve. Is it true? And can you help me find the part number? VW has one for $250 but I think that is too much

I replace the piece you did .didnt fix it i needed complete valve

The kit may be great, the video does not address the issue of oil ingress into pump!!!!!!!!!! Oil ingress is via the rotary part of the pump that also has a seal.

ı have seen much oil in pump side. ıs that normal or excessive ?

I cannot get the job button to open. Your video shows it easily coming out, mine won’t budge. Any tips?

I just changed both gaskets, torqued everything and it still leaks. Would a new pump help?

I did this easily without dropping compressor

Anyone who whatching this and will replace seals, you have to know: before puting all together inject engine oil inside, or you can get what I got, chain broken.

Stupid music

hi i have a question is this also a repair if ac wont give cold air when car has no movment or rpm with gas pedal, but when its on movment on 1500-2000rpm ??

good

Awesome video!

What dose it do if the membrane is broken...wierd sound from that smal hole?

I need help with my compressor (SANDEN R134A /1351F) valve where mistakenly I buy new without valve , it's looks like exact same as the original but the original valve size and shape not fit in the hole of that new compressor

Does this kit help when the brake pedal is hard and the issue is confirmed vacuum pump failure (pump is hardly making vacuum)?

Do you lose about a qt of oil a month of this part is bad?

So I have a 2.0L non turbo and I have an oil leak from throttle body dealer said it was because pcv failure is this the same procedure for N/A

I just installed this to my car (audi b8 2010 2.0L) and at startup it makes a knocking sound, then after that everything runs fine… Maybe I didnt screw it all the way in?? what do you think?

I started this job today, expecting an easy, but dirty, fix. Drain the oil, spray brake clean all over, get my T25, and VOILA, the two T25's are stripped!! I guess that's why the previous owner wanted to sell the car!! Does anyone know the best way to go about removing these two stripped screws? 2010 L322. TIA!

The airco on my sons mk5 Golf does not work. Compressor spins and system has 525grams of filling inside. Both high and low pressure side have the same pressure. Between 2 and 3 bar's. Is it possible that it's just a defect valve? He measured the signal on the connector of the valve so that's okay. I see a lot of different valve's when i search on 'Golf mk5'. Different shapes (longe, short, wired connector, build in connector). Do they all fit or not? Thanks ;-)

I have the AJ126 3.0 SC V6 and found just one on the back left side of the engine when you're looking from the front of the car. Is that the only one?

Where is the best place to put this broken part?

Exactly what I needed, thank you so much. You saved me almost $1000

Same deal on the b5.5 2.8l V6?

Kindly what is the valve for highlander 2013 3.5 gasoline engine

thanks! was just wondering if this could be done.

Hey is this what needs to be done when sunshade start acting like its possed?

Shoukda added nut/bolt sizes

Thanks.🎉

Thank you so much ❤

Straight to the point and well explained video, thank you.

I replaced the seals on my 2013 LR4 this weekend. Thanks to the kit and this video, it was very straightforward. I drained the oil first, so only a few drops of oil came out when removing the pump.

I'm having similar issues with a 2010 A4. Can't find a board for an A4 wondering if the E380 is the same as the one I need?

Donde la puedo comprar

Hi. Nice video, can you please share me the link of where i may get a new pinion seal for the range rover vogue tdv6 l322?

❤❤❤❤greetings for u from Iraq

I have p0171 code system to lean

air blowing out of the breather hole is normal?

Thank u for showing how to perform vacuum finger test. Simple video with easy diy repair.

thx

Where can i get those little metal clips?

Thanks so much bro. I spent 4 hours last night trying and watching videos and nothing helped. Your video helped me in 10 minutes and it was an LED. Just got a subscriber. 🙌🏾

is it feel suction or how

Thx so much for the vid, helped me fix my new aftermarket shift knob 👍

Why's the left gauge so rude past 800 mm/Hg vac? 🤣

I thought the supercharge 6 has one?

Great video for any door panel removal, used it as a tutorial for the lock actuator replacement. Not agreeing with sticking the screwdriver to hold the window.